Commissioning Manual
01/2017
53
Establishing a network connection
Proceed as follows to establish a network connection:
Connect the control system with the local network using an Ethernet cable.
Select the system data operating area on the PPU.
Press this key to view the extended softkeys.
Enter the main screen of the service control optio
ns through the following softkey opera-
Press this softkey to enter the window for the network configuration.
make sure the following vertical softkey is not selected:
the network as required in the following window:
u can configure DHCP with the following key:
I
f you select "No" for DHCP, you must enter the IP address (which must belong to the
same network as that of your computer) and subnet mask manually.
Press this softkey to save the configuration. If you select "Yes" for DHCP, you also need to
restart the control system to activate the network configurati
on.
Start AMM on your computer. A password setting dialog box appears when the tool is star
t-
Enter a desired password in the input fields and then click this button to save.
This password ensures that all the connection data for AMM is encrypted. The password
can be subsequently changed at any time from the menu bar.
To Next Page
Loading...
Need help?
General
