Siemens SINUMERIK 840Di sl - First Power-Up; Basic Commissioning of the System Software

Power-On and Power-Up
5.2 First power-up
Manual
124 Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
5.2 First power-up
5.2.1 Basic commissioning of the system software
Objective of basic commissioning
After the basic commissioning described in the following two sections, the following
conditions should apply:
● SINUMERIK 840Di sl NC and PLC are operated in cyclical operation
● If a machine control panel is connected, no alarms or messages should be pending.
● The displayed axes of the NC can be traversed by simulation.
Factory settings
The hard disk of the PCU is already partitioned upon delivery for operating the SINUMERIK
840Di sl. Additional software applications, which have been been ordered, e.g. HMI
Advanced, are ready for installation under:
● D:\Setup\Apps\<
Application1 > . . . < Application n >
1DPH(0(5*(1&<
&RQWHQW:LQ3(
1DPH6<67(0
&RQWHQW:LQGRZV;3
1DPH703
&RQWHQW,PDJHV
6HWXSV8SGDWHV
1DPH86(5
&RQWHQW'LVO
([WHQGHGSDUWLWLRQZLWKORJLFGULYHV
3ULPDU\SDUWLWLRQ
&
17)6
'
17)6
(
17)6
)
17)6
Figure 5-1 Partitioning the hard disk
Installing the software
When the PCU is first booted, the following menu is displayed: