Siemens SINUMERIK 840Di sl - Interface Signals Not Supported

840Di-specific data and functions
18.1 Interface signals
Manual
588 Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
18.1.2 Interface signals not supported
DB number Byte, bit Name
Axis/spindlespecific signals from PLC to axis/spindle
31, ... 20.0 Acceleration switch V/Hz operation
31, ... 20.2 Torque limit 2
Safety Integrated signals from PLC to axis/spindle
31, ... 22.0 Deselection of safe velocity and zero speed (deselection of SBH/SG)
31, ... 22.1 Deselection of safe operational stop (deselection of SBH)
31, ... 22.3 Velocity limit, bit value 0 (SG selection)
31, ... 22.4 Velocity limit, bit value 1
31, ... 23.0-23.2 Speed ratio selection, bit value 0 to bit value 2
31, ... 23.5 Enable limit switch pair 2
31, ... 23.7 Activate test stop
Signals from axis/spindle to PLC
31, ... 92.0 Setup mode is active
31, ... 92.2 Torque limit 2 active
Safety Integrated signals from axis/spindle to PLC
31, ... 108.0 Safe velocity or zero speed (SBH/SG active)
31, ... 108.2 Clear status pulses
31, ... 108.7 Axis safely referenced
31, ... 109.0-109.7 Cam signals of plus and minus cams (SN1+/1- to SN4+/4-)
31, ... 110.1 Safe operational stop active (SBH active)
31, ... 110.3-110.4 Safe velocity active, bit value 0 to bit value 1
31, ... 110.5 n < n
x
31, ... 111.1 Safe operational stop active (SBH active)
31, ... 111.4-11.7 Stop A/B to Stop E active