Drive Optimization with HMI Advanced
14.6 Trace function
Manual
530 Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
14.6.4 Performing the measurement
Softkey: Start
After parameterization has been completed, you enable measurement by pressing the Start
softkey.
The measurement is carried out once the set trigger condition of trace 1 is fulfilled.
Terminating the measurement
The measurement is completed after the set measurement duration is expired.
The graphics are generated automatically when the measurements are finished. Use the
Display softkey to call the display functions of the graphics (see next Section).
Softkey: Stop
You can cancel a running measurement at any time with the Stop softkey. A canceled
measurement cannot be displayed.
To Next Page
Loading...
