Drive commissioning (SIMODRIVE)
10.1 SIMODRIVE 611 universal/E, POSMO CD/CA and SI
Manual
350 Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
10.1.5 Setting the access interface
Parameter assignment
The access interface through which SimoCom U accesses the drives connected to
PROFIBUS by means of routing, must be parameterized as follows:
● Access point of the application
S7ONLINE STEP7 --> SOFTMC
The interface can be parameterized directly from SimoCom U. To do so, proceed as follows:
1. Start SimoCom U via the WINDOWS taskbar:
Start > Programs > SimoComU > SimoComU
2. In SimoCom U, open the interface dialog using the menu command:
Tools > Communication
SimoCom U dialog box: Beginning
Dialog: Interface
Radio button: "Route through S7-CPU" ⊙
Button: "Set PG/PC interface..."
PG/PC interface dialog box: Beginning
Dialog: Setting the PG/PC interface
Tab: Access path
Access point of the application:
S7ONLINE STEP7 --> SOFTMC
Interface parameter assignment used:
SOFTMC
PG/PC interface dialog box: End
If SOFTMC cannot be selected for the interface parameterization, the interface has to be
installed first.
Button: "Select..."
Dialog: Install/remove interface
Selection: SOFTMC
Button: "Install-->"
Close
OK
Finally, the routing information must be set in the interface dialog of SimoCom U.
To Next Page
Loading...
