Siemens SINUMERIK 840Di sl - 6.9.3 Saving setup data

Drive commissioning (SINAMICS)
9.5 Basic principles
Manual
342 Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
9.5 Basic principles
9.5.1 Drive unit: Upgrade firmware
The firmware of a drive unit is upgraded using the STARTER commissioning tool.
Requirements
This procedure requires a functional project and a CF card with the new firmware.
Implementation
Perform the following actions to upgrade the firmware:
1. Create a network link between the PG/PC and the drive unit.
2. Access the drive unit with the PG/PC online and load the current project into the PG/PC
from the drive unit.
3. Save the project with a new project name by selecting "Save As..." and close the old
project.
4. Click the drive unit in the project view to convert the project to the new version and select
"Target system" > "Device version..." (1) from the menu.
Select the version to which the project should be upgraded (2) and start the conversion
process using the button "Change version" (3).



&KDQJLQJYHUVLRQV
&ORVH
6,1$0,&669[
6,1$0,&669[
6,1$0,&669[
6,1$0,&669[
&XUUHQWYHUVLRQ
'HYLFHYHUVLRQ
$YDLODEOHYHUVLRQV
&RS\IURP5$0WR520
/RDGWRWDUJHWV\VWHP
/RDGWR3*
5HVWRULQJWKHIDFWRU\VHWWLQJV
2QOLQHDFFHVV
'HYLFHYHUVLRQ
3URSHUWLHV
2YHUYLHZ
2SHQFRQILJXUDWLRQ
,QVHUWQHZREMHFW
2SHQ+:FRQILJXUDWLRQ
&XW
&RS\
3DVWH
3ULQW
([SHUW
7DUJHWGHYLFH
5HQDPH
'HOHWH
3ULQW3UHYLHZ
7RSRORJ\
'ULYHB8QLWB$GGU
$GGLQGLYLGXDOGULYH
3URMHFW
3URMHFW(GLW7DUJHW6\VWHP9LHZ7RROV:LQGRZ+HOS
67$57(53URMHFW
5. Switch off the Control Unit and insert the CF card with the new firmware version. Then
switch the Control Unit on again.