General Information on the SINUMERIK 840Di sl
1.3 Notes on startup
Manual
34 Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
1.3 Notes on startup
Described components
This SINUMERIK 840Di sl Manual describes the basic commissioning of the following
components:
● SINUMERIK 840Di sl NC and PLC
● SINAMICS S120 drives
● Ethernet communication
● PROFIBUS DP and DP components
Note
We recommend performing commissioning of the SINUMERIK 840Di sl according to the
sequence in which the chapters of this manual are laid out.
Software
For commissioning the following software is required (part of a SINUMERIK 840Di sl):
● NCK commissioning:
– 840Di startup
– SinuCom NC
● PLC commissioning, including PROFIBUS communication:
– SlaveOM for SIMODRIVE drives
– PLC basic program
● SIMODRIVE drive commissioning
– SimoCom U
Additional software
For commissioning the following software is required (not part of a SINUMERIK 840Di sl):
● PLC commissioning, including PROFIBUS DP communication:
– SIMATIC Manager STEP 7: as from Version 5.3, Service Pack 2
– SlaveOM for SINAMICS drives (part of STARTER)
● SINAMICS drive commissioning
– STARTER
To Next Page
Loading...
