Siemens SINUMERIK 840Di sl - Parameterization of the MCP

PROFIBUS DP Communication
8.6 DP slave MCP 310
Manual
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
255
8.6.2 Parameterization of the MCP
Interfaces
In the following figure, the interfaces are shown on the rear side of the module:
COM-Board
&20%RDUG
5RWDU\VZLWFK;;
3RZHUVXSSO\;
/('V 352),%86;
+DQGZKHHOV;;
+DQGZKHHOVLJQDOW\SH6
7HUPLQDWLRQ
(TXLSRWHQWLDOERQGLQJFRQGXFWRU
&XVWRPHUVSHFRSHUDWLRQHOHPHQWV;;
.H\VZLWFK;
6',3VZLWFK
'LUHFWNH\V;
Figure 8-11 Rear of the MCP 310 showing the control and display elements and the interfaces

6KLHOG03
Figure 8-12 Connection overview: Power supply X10
For a detailed description of the electrical and mechanical design and of the machine control
panel interfaces, please refer to:
References:
/BH/ Operator Components Manual, Chapter "MCP 310 Machine Control Panel"