Siemens SINUMERIK 840Di sl - HW Config

PLC commissioning
6.3 Creating a SIMATIC S7 project
Manual
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
163
6.3.3 HW Config
The user interface of "HW Config" mainly contains:
● Station window:
The station window is split. The upper part displays the structure of the station graphically,
and the lower part provides a detailed view of the selected module.
● Hardware catalog
If the hardware catalog is not displayed, open it using the menu command View >
Catalog.
Profil:
Suchen:
+:&RQILJ>6,180(5,.FRQILJXUDWLRQ6,1'LVO@
6WDWLRQ(GLW,QVHUW7DUJHW6\VWHP9LHZ7RROV:LQGRZ+HOS
6WDWLRQVZLQGRZVWDWLRQVWUXFWXUH
6WDWLRQVZLQGRZ'HWDLOHGYLHZ
+DUGZDUHFDWDORJ
352),%86'3
352),%863$
352),1(7,2
6,0$7,&
6,0$7,&
6,0$7,&3&%DVHGFRQWURO
6,0$7,&3&6WDWLRQ
GHIDXOW
6ORW'HVLJQDWLRQ
Figure 6-4 HW Config: Names of the main areas
Note
To check whether a module selected from the hardware catalog complies with the
module in the automation system, the following procedure is recommended:
1. Note the MLFB numbers of all modules used in the automation system.
2. Select the appropriate module from the hardware catalog and compare the order
number (MLFB) displayed with the noted MLFB number. The MLFB numbers must be
identical.