Siemens SINUMERIK 840Di sl - Create New Project Without Project Wizard

Drive commissioning (SINAMICS)
9.2 ONLINE commissioning
Manual
310 Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
9.2.1 Create new project without Project Wizard
Implementation
Perform the following actions for creating the new project and for entering the online
connection data:
1. Start the STARTER drive commissioning tool using the icon on the user interface or the
Windows taskbar Start > SIMATIC > STEP 7 > STARTER.
Close the Project Wizard which may have been opened when starting the STARTER for
creating a new project.
2. Create a new project via the menu item Project > New ... .
3. For inserting the drive unit in the project navigator right-click on the project element Insert
Single drive unit. Thereupon, the menu "Einfügen - SINAMICS" ("Insert - SINAMICS") is
shown.
67$57(53URMHFW
3URMHFW(GLW7DUJHW6\VWHP9LHZ7RROV:LQGRZ+HOS
3URMHFW
,QVHUWLQJDVLQJOHGULYHXQLW
Figure 9-1 Insert single drive unit (Section)
4. Set the corresponding data of the available system in the menu "Insert - SINAMICS" in
the tab "Drive unit/bus address". As an example, the following data is set:
,QVHUW6,1$0,&6
*HQHUDO 'ULYH8QLW%XV$GGUHVV
'HYLFHW\SH
'HYLFHYHUVLRQ
2QOLQHDFFHVV
$GGUHVVW\SH
%XVDGGUHVV
6,1$0,&66&8
6ORW
[
352),%8686633,


Figure 9-2 Parameterize drive unit (section)