Siemens SINUMERIK 840Di sl - Display Function

Drive Optimization with HMI Advanced
14.6 Trace function
Manual
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
531
14.6.5 Display function
If you press the Display softkey after the set measurement time has expired and the
measurement results have been prepared automatically, you can call the graphical display
function of the measurement results.
-RJ
?03)',5
7(6703)
)LOH
IXQFWLRQV
'LVSOD\
529
&KDQQHOUHVHW
3URJUDPDERUWHG
6WDUWXS
0HDVXUH
PHQW
$[LV0'
8VHU
YLHZV
;PDUNHU
2Q
<PDUNHU
2Q
)XOOVFUHHQ
6FDOH
*UDSKLFV
7UDFH
6WDUW
*UDSKLFV7U;D[LV7U<D[LV!
7U3RVDFWYDOPHDVV\V


PP


!PPPLQ




/LQPV
/LQPV

PP


PPPLQ

75B
*UDSKLFV7U;D[LV7U<D[LV!
7U6HWYHORFLW\
7UB 7UB
75B
7U3RVDFWYDOPHDVV\V
7U6HWYHORFLW\
6HUYLFH
D[LV
Figure 14-10 Measurement results: Trace function
Softkeys: X-marker on, Y marker on
The X marker on and Y marker on sofkeys are used to display a vertical or horizontal red line
with a red circle on the measuring curve in the diagrams.
The associated values, e.g. for damping, frequency, degrees, etc. are displayed in the
appropriate diagram.
Use the cursor keys to move the markers:
● Slow: Cursor key
● Fast: Shift key + cursor key