Siemens SINUMERIK 840Di sl Commissioning Manual

Drive commissioning (SINAMICS)
9.2 ONLINE commissioning
Manual
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
327
9.2.11 Control Unit: Output "Infeed ready for activation" (BICO interconnection) signal
To output the "Infeed ready to start" signal at terminal X132.8 of the Control Unit, parameter:
"r899, Bit 0" of the infeed must be connected to parameter: "p743" of the Control Unit via
BICO interconnection and terminal X132.8 of the control unit must be parameterized as
DO13 output:
● Infeed: r899 Bit 0: Ready to power up
● Control Unit: p743, BI: CU signal source for terminal DI/DO 13
Implementation
Perform the following actions:
1. To open the terminal configuration in the project navigator double-click on. Project > Drive
unit_Adr10 > Control Unit > Inputs/outputs.
2. In the "Bidirectional digital inputs/outputs" tab (1), change the status for terminal X132.8
to "Output" (2)
3. Click the binector input icon of terminal X132.8, DO13 (3) and select the signal: Infeed
"r899: Bit0, ... Infeed ready to start" (4).





;


'2
'2


,QYHUWRXWSXW
'LJLWDOLQSXWV%LGLUHFWLRQDOGLJLWDOLQSXWVRXWSXWV 0HDVXULQJVRFNHWV
2XWSXW
2XWSXW

,QIHHGU%LW&2%2




&RQWUROB8QLW
'ULYHB
'ULYHB
'ULYHB
,QIHHG
)XUWKHULQWHUFRQQHFWLRQV
U%LW&2%26WDWXVZRUGVHTXHQFHFRQWUROLQIHHG5HDG\IRURSHUDWLRQ <HV 1R
U%LW&2%26WDWXVZRUGVHTXHQFHFRQWUROLQIHHG5HDG\WRVWDUW <HV 1R
U%LW&2%2'ULYHFRXSOLQJVWDWXVFRQWUROZRUG&RQWUROOLQHFRQWDFWRU <HV 1R
,QIHHG&RQWUROB8QLW
+HOS

Siemens SINUMERIK 840Di sl Specifications

General

Brand	Siemens
Model	SINUMERIK 840Di sl
Category	Control Unit
Language	English