Siemens SINUMERIK 840Di sl - Parameterization of the MCP

Ethernet communication
7.5 MCP 483C IE
Manual
192 Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
References:
The following manuals are required for the commissioning of the MCP:
/FB1/Function Manual, Basic Functions Subsection P3, PLC Basic Program, Program
structure and modules of the PLC basic program.
/FB2/Function Manual, Extended Functions, Section H1, Manual and Handwheel Travel,
Commissioning of handwheels
/BHsl/Operator Components Manual, Description of MCP (interfaces, electrical connection,
etc.)
/Z/ Catalog NCZ, Connection components: Cables, connectors, etc.
Automation system
To commission the MCP the automation system must be completely electrically and
mechanically connected with respect to NC, PLC and MCP.
The drives must be secured against accidental moving.
7.5.2 Parameterization of the MCP
Interfaces
In the following figure, the interfaces are shown on the rear side of the module:
*URXQG7HUPLQDO
5RWDU\6ZLWFK
;;
(WKHUQHWFRQQHFWLRQ
(WKHUQHW;
(WKHUQHW;
(PHUJHQF\6WRS
3RZHUVXSSO\;
;;
+DQGZKHHOFRQQHFWLRQ
+DQGZKHHOVLJQDOW\SH6
',3VZLWFK6/('V
&XVWRPHUVSHF
LQSXWVRXWSXWV
6ORWVIRU
DGGLWLRQDOFRPSRQHQWV
Figure 7-4 Position of interfaces on rear side of machine control panel
For a detailed description of the electrical and mechanical design and of the machine control
panel interfaces, please refer to: