Siemens SINUMERIK 840Di sl - 6.8.2 Simulation settings

Drive commissioning (SINAMICS)
9.2 ONLINE commissioning
Manual
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
325
9.2.9 Control Unit: Acknowledge error (BICO interconnection)
To acknowledge an error for the Control Unit, use the "PROFIBUS PDA1 received" signal
from the first drive.
● Control Unit: p2103 BI: 1. Acknowledge faults
● Drive: Drive_1, r2090: Bit7, BO: PROFIBUS PZD1 receive bit-serial
Implementation
Perform the following actions:
1. To open the control logic configuration in the Project Navigator, double-click Project >
Drive unit_Adr10 > Control Unit > Control Logic.
2. Click on the binector input icon of Signal "p2103 BI: 1. Acknowledge Errors" and select
from the "Drive_1 > Other interconnections > r2090: Bit7, BO: PROFIBUS PDA1 receive
bit-serial" list.









S%,$FNQRZOHGJHIDXOWV
LVLQWHUFRQQHFWHGZLWK
'ULYHBU%LW%2352),%863'$UHFHLYHELWVHULDO%LW 2XW ,Q
&ORVH +HOS
&RQWUROB8QLW
6WDWXVZRUGIDXOWVDODUPV
U%LW$ODUPDFWLYH
U%LW,QWHUQDO0HVVDJHDFWLYH
U%LW$FNQRZOHGJHPHQWUXQQLQJ
S%,([WHUQDODODUP
S%,$FNQRZOHGJHIDXOWV
S%,$FNQRZOHGJHIDXOWV
2SWLPL]HYLHZ
&RQWUROZRUGIDXOWVDODUPV
&RQWURO/RJLF
S%,$FNQRZOHGJHIDXOWV
$QWULHEBU%LW%2352),%