Siemens SINUMERIK 840Di sl - Infeed: Acknowledge Error (BICO Interconnection)

Drive commissioning (SINAMICS)
9.2 ONLINE commissioning
Manual
328 Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
9.2.12 Infeed: Acknowledge error (BICO interconnection)
To acknowledge an error for the infeed, use the "PROFIBUS PDA1 received" signal from the
first drive.
● Infeed: p2103[0] BI: 1. Acknowledge faults
● Drive: Drive_1, r2090: Bit7, BO: PROFIBUS PZD1 receive bit-serial
Implementation
Perform the following actions:
1. To open the control logic configuration in the Project Navigator, double-click Project >
Drive unit_Adr10 > Infeeds > Infeed > Control logic.
2. Click on the binector input icon of Signal "p2103[0] BI: 1. Acknowledge Errors" and select
from the "Drive_1 > Other interconnections > r2090: Bit7, BO: PROFIBUS PDA1 receive
bit-serial" list.
&RQWURO/RJLF
2SWLPL]HYLHZ
&RQWUROZRUGVHTXHQWLDOFRQWUROLQIHHG   &RQWUROZRUGIDXOWVDODUPV
S>@%,212))

S>@%,2))

S>@%,2))
,QIHHG
U>@%,$FNQRZOHGJHIDXOWV
'ULYHBU%LW%2352),%
U>@%,$FNQRZOHGJHIDXOWV

S%,$FNQRZOHGJHIDXOWV
LVLQWHUFRQQHFWHGZLWK
'ULYHBU%LW%2352),%863'$UHFHLYHELWದVHULDO%LW 2XW ,Q
&ORVH+HOS