Siemens SINUMERIK 840Di sl - Creating a PLC Program; PLC Basic Program

PLC commissioning
6.4 Creating a PLC program
Manual
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
177
6.4 Creating a PLC program
6.4.1 PLC basic program
Opening the library
For inserting the basic PLC program in the created S7 project SIN840Di sl open the library
installed in the Subsection
"Installation of the basic PLC program library" (Page 151) via the
menu command File > Open.
Select the library for the PLC basic program, e.g.
gp8x0d65, and confirm the dialog with
"OK".
2SHQLQJDSURMHFW
8VHUSURMHFWV/LEUDULHV([DPSOHSURMHFWV0XOWLSOHSURMHFWV
1DPH6WRUDJHSDWK
JS[G)?3URJUDP)LOHV?6LHPHQV?6WHS?6OLEV?JS[G
PFS'L)?3URJUDP)LOHV?6LHPHQV?6WHS?6SURM?PFS'L
6,0$7,&B1(7B&3)?3URJUDP)LOHV?6LHPHQV?6WHS?6OLEV?VLPDWLFQ
6WDQGDUG/LEUDU\)?3URJUDP)LOHV?6LHPHQV?6WHS?6OLEV?6WG/LE
VWGOLEV9)?3URJUDP)LOHV?6LHPHQV?6WHS?6OLEV?67'/,%6
Figure 6-8 Opening the library of the PLC basic program
Copying blocks
Copy all blocks of the PLC basic program from the library to the block directory of the PLC.