Siemens SINUMERIK 840Di sl - Alarm and Message Texts; Configuration File MBDDE.INI

Manual
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
493
Alarm and message texts
12
To enable easy adaptation of alarm and message texts to the specific requirements of an
automation system, the alarm and message texts are stored in freely accessible ASCII text
files.
The alarm and message texts contained in the text files are used commonly by all
SINUMERIK user interfaces:
● SinuCom NC
● 840Di startup
● HMI Advanced
By changing/modifying the texts or files or by creating new texts/files, a flexible adaptation to
the current requirements is possible.
Storing the text files
The files containing the alarm and message texts are stored on the hard disk in the directory
<Installationpfad>\dh\mb.dir\.
12.1 Configuration file MBDDE.INI
Structure of the file MBDDE.INI
The alarm and message texts that are to be used are set in the
<Installationspfad>\mmc2\mbdde.ini file. For this purpose, the appropriate paths to the
application-specific standard and user files must be stored in the [Textfiles] section of file
MBDDE.INI.
Excerpt of the "MBDDE.INI" file:
...
[Textfiles]
MMC= <Installationspfad>\dh\mb.dir\alm_
NCK= <Installationspfad>\dh\mb.dir\aln_
PLC= <Installationspfad>\dh\mb.dir\plc_
ZYK= <Installationspfad>\dh\mb.dir\alz_
CZYK= <Installationspfad>\dh\mb.dir\alc_
UserMMC=
UserNCK=