Siemens SINUMERIK 840Di sl - Page 492

NC Commissioning with HMI Advanced
11.11 NC/PLC Diagnosis
Manual
492 Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
Apply changes
To apply the changes you have made, press the "Accept" softkey. The message box that is
then displayed has to be acknowledged again with the "Accept" softkey.
The "Cancel" softkey rejects all changes and displays the original settings again.
3URSHUWLHV
$FFHSWLQJWKHFKDQJHFDQOHDGWRORVVRI1&XVHUGDWD
0DNHVXUHWKDWWKLVGDWDKDVEHHQVWRUHGLQDVHULHVVWDUWXSILOH
0HPRU\VHWWLQJVKDYHEHHQFKDQJHG
&KDQJHVZLOOQRWWDNHHIIHFWWLOOWKHV\VWHPLVUHERRWHG
7KHVKXWGRZQUHVSRQVHKDVEHHQFKDQHG
,QFRUUHFWFRQILJXUDWLRQZLOOUHVXOWLQORVVLQGDWDLIWKHUHLVDSRZHUIDLOXUH
'R\RXUHDOO\ZDQWWRDFFHSWFKDQJHV"
$FFHSW
3URSHUWLHV
'LDJQRVWLFV
&KDQQHO5(6(7
&DQFHO
&RPPLVVL
RQLQJ
-2*5HI&+$1
529
3URJUDPDERUWHG
03)
Figure 11-36 Applies settings.
NOTICE
We urgently recommend creating a series startup file before changing the data described
above. See Chapter
"User data backup/Series Statup" (Page 541).