NC Commissioning with HMI Advanced
11.6 Handwheels
Manual
464 Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
Table 11-51 Logical base addresses
Machine data Value Description
MD11353 $MN_HANDWHEEL_LOGIC_ADDRESS [0] 288 Logical base address handwheel slot 1st MCP
MD11353 $MN_HANDWHEEL_LOGIC_ADDRESS [1] 304 Logical base address handwheel slot 2nd MCP
MD11353 $MN_HANDWHEEL_LOGIC_ADDRESS [4] 330 Logical base address handwheel slot 4th MCP
MD11353 $MN_HANDWHEEL_LOGIC_ADDRESS [5] 320 Logical base address handwheel slot 3rd MCP
11.6.4 Connection via Ethernet
Parameter assignment
Parameterization of handwheels connected via Ethernet modules, e.g. machine control
panel "MCP 483C IE", "HT 8" or "HT 2" is done with the following NC machine data:
● MD11350 $MN_HANDWHEEL_SEGMENT[< x - 1 >] = 7
When connected via Ethernet module, the segment always has to be entered as 7
(Ethernet).
● MD11351 $MN_HANDWHEEL_MODULE[< x - 1 >] = 1
When connected via Ethernet module, the module always has to be entered as 1.
● MD11352 $MN_HANDWHEEL_INPUT[< x - 1 >] = y
with y = 1, 2, 3, ... (handwheel interface at the Ethernet bus)
with x = 1, 2, 3, ... (handwheel number in the NC)
Handwheel interfaces at Ethernet Bus
The numbering of the handwheel interfaces at the Ethernet bus results from the following
considerations:
● The sequence of the operator component interfaces is: MCP1, MCP2, BHG
● Each operator component interface has two handwheel interfaces
● Operator components: MCP 483C IE
A maximum of two handwheels can be connected to an MCP 483C IE via the
connections X60 and X61. The assignment of the connections in the operator component
interface is:
– Connection X60: 1. Handwheel in the operator component interface MCP1 / MCP2
– Connection X61: 2. Handwheel in the operator component interface MCP1 / MCP2
● Operator components: HT 8
The handwheel of the HT 8 is always assigned to the 1st handwheel of the operator
component interface MCP1 / MCP2.
● Operator components: HT 2
The handwheel of the HT 2 is always assigned to the 1st handwheel of the operator
component interface BHG.
To Next Page
Loading...
