Siemens SINUMERIK 840Di sl - Parameter Assignment

Drive Optimization with HMI Advanced
14.6 Trace function
Manual
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
527
,IWKHFXUVRULVSODFHGRQDOLVW
ER[SUHVVWKH,QVHUWNH\WR
RSHQWKHOLVWER[
7KHFXUVRULVFRQWUROOHG
XVLQJWKHDUURZNH\VRQ
WKHRSHUDWRUSDQHORUZLWK
WKHPRXVH
7RJJOHNH\
<RXFDQVFUROOGRZQE\
XVLQJWKHDUURZNH\V
<RXDFFHSWDYDOXH
XVLQJWKHLQSXWNH\
Figure 14-8 Cursor operation
14.6.3 Parameter assignment
Parameterization in the basic display
The following settings have to be made in the basic screen
● The axis/spindle to be measured
● The signal to be measured
● Measurement time
● Trigger time
● Trigger type
● Trigger threshold
Input field: Axis/spindle name
The cursor must be positioned on the Axis/Spindle name of the relevant trace. You can
select it with the softkeys Axis+ and Axis- or by accepting a value from the dropdown list.
Input field: Signal selection
The cursor must be positioned on the Signal selection list field of the relevant trace. Then
activate the desired items by selecting them from the list box.
Measuring parameters