Power-On and Power-Up
5.4 Service Desktop
Manual
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
137
● Folder: SINUMERIK 840Di
– SINUMERIK 840Di Startup
Simple SINUMERIK 840Di-specific user interface.
– NT Desktop/HMI Desktop
Autostart of the HMI application: OFF/ON
See Section
"Setting the boot response for the service desktop" (Page 138).
– Readme
Tips and boundary conditions for the installed \SINUMERIK 840Di sl-system software.
● Folder: SINUMERIK 840Di > tools
– HT8TCU
Activation of the transfer of an HT8 machine control panel signal
References:
Equipment Manual "Operator components and Networking",
Chapter: Networking
– Install-Deinstall MCIS RCS Host
Installation and uninstall program of the host for remote diagnostics of SINUMERIK
systems with Windows-based HMI within the framework of the Motion Control
Information System.
References:
Catalog NC 61: Motion Control Information System (MCIS)
● Folder: SinuCom NC
– CT Editor
Tool for creating the test templates
– NC Connect Wizard
Tool for establishing the communications link from SinuCom NC to SINUMERIK 840Di
sl.
– SinuCom NC
NOTICE
When Windows starts up, the SINUMERIK 840Di sl NC system software is
automatically started in the background.
To Next Page
Loading...
