Siemens SINUMERIK 840Di sl - Page 273

PROFIBUS DP Communication
8.7 DP slave MCP 483
Manual
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
273
VWGLJLW
OHIW/('%ORFN
QGGLJLW
FHQWHU/('%ORFN
UGGLJLW
ULJKW/('%ORFN
(QDEOHVRIWZDUHYHUVLRQGLVSOD\
SUHVVERWKNH\VVLPXOWDQHRXVO\
Figure 8-18 MCP software version display
Switch S3
The PROFIBUS address and the connection type are set via Switch S3 on the rear side of
the MCP:
Table 8-4 Switch S3: PROFIBUS address (1-7)
10 9 8 7 6 5 4 3 2 1 Meaning/value
on on - - - - - - - - Connection type: PROFIBUS
- - off - - - - - - - Reserved
PROFIBUS address
- - - off off off off off off off 0
- - - off off off off off off on 1
- - - on off off off off on off 2
- - - off off off off off on on 3
- - - : : : : : : : :
- - - on on on on on on off 126
- - - on on on on on on on 127
The switch position 10-8 are to be set according to the data in the table.
NOTICE
In the delivery condition, MPI is to be set as connection type (10-9: off, off).