Siemens SINUMERIK 840Di sl - 6.8 Program simulation

Drive commissioning (SINAMICS)
9.2 ONLINE commissioning
Manual
314 Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
3. Set the PG/PC interface if required and test whether all SINAMICS drive units connected
to the PROFIBUS which are to be commissioned as part of this project are accessible via
the PG/PC interface. To go to the corresponding dialog box, click the "Change and
test...." button.
Note
The stations accessible via the PG/PC interface are displayed in the SIMATIC NET
diagnostic screen.
Then click the "Continue >" button:
&3352),%86
%DFN &DQFHO

6XPPDU\

,QVHUW
GULYH
GHYLFH

6HW3*3&
LQWHUIDFH

&UHDWHD
QHZSURMHFW
,QWURGXFWLRQ
&RQWLQXH!
&KDQJHDQGWHVW
6HW
LQWHUIDFH
67$57(53URMHFW:L]DUG
6SHFLI\WKHRQOLQHFRQQHFWLRQWRWKHGULYHXQLW
4. Add the accessible SINAMICS drive units to the project.
The drive units found are displayed in the preview window. In the example, a drive unit
"Drive_Unit_Addr10" has been located.
Then click the "Continue >" button:
'ULYHB8QLWB$GGU
3URMHFW
%DFN &DQFHO&RQWLQXH!
5HIUHVK
YLHZ
67$57(53URMHFW:L]DUG
3UHYLHZ

6XPPDU\

,QVHUW
GULYH
GHYLFH

6HW3*3&
LQWHUIDFH

&UHDWHD
QHZSURMHFW
,QWURGXFWLRQ