NC Commissioning with HMI Advanced
11.5 Axes and spindles
Manual
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
395
Number Name Name/remarks
30210 ENC_SEGMENT_NR[0] Actual value assignment Drive type
5 = PROFIBUS DP
30220 ENC_MODULE_NR[0] Actual value assignment: Logical drive number for position
measuring system 1
30220 ENC_MODULE_NR[1] Actual value assignment: Logical drive number for position
measuring system 2
30230 ENC_INPUT_NR[0] Actual value assignment: Position measuring system 1
1 = motor measuring system
2 = direct measuring system
30230 ENC_INPUT_NR[1] Actual value assignment: Position measuring system 2
1 = motor measuring system
2 = direct measuring system
30240 ENC_TYPE[0] Actual-value acquisition modes
0 = simulation
1 = incremental encoder
4 = absolute encoder with EnDat interface
Interface signals
Table 11-18 Switchover of position measuring system: Interface signals
DB number Bit, byte Name
Axis/spindle-specific Signals from PLC to axis/spindle
31, ... 1.5 Position measuring system 1
31, ... 1.6 Position measuring system 2
References:
/FB/ Function Manual - Basic Functions, G2 Velocities, Setpoint/Actual Value Systems,
Control, Chapter "Setpoint/Actual Value System"
/FB/ Function Manual - Basic Functions, A2 Various Interface Signals, Subsection "Interface
Signals to Axis/Spindle"
To Next Page
Loading...
