Siemens SINUMERIK 840Di sl - Page 404

NC Commissioning with HMI Advanced
11.5 Axes and spindles
Manual
404 Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
(QFRGHUV
&\FOHV\QFKURQLVDWLRQ&RQILJXUDWLRQ*HQHUDO
$[LV0HVVDJH)UDPH3='
&RQVLVWHQF\8QLW/HQJKW,2$GG357\SH$GGU7\SH
7RWDO/HQJWK:RUG2XWSXW3'$
7RWDO/HQJWK:RUG,QSXW3'$
$FWXDO9DOXH
6HWSRLQW
1R3.:



'ULYH 352),%863DUWQHU6ORW
'3VODYHN3URSHUWLHV
Figure 11-13 DP slave properties: SIMODRIVE 611U
ADI4:
● Message frame type: Standard message frame 3
● I/O address: 4200





'3VODYHSURSHUWLHV
*HQHUDO
($$GGU35
3='
3='
&RQVLVWHQF\8QLW/HQJWK7\SH$GGU7\S
7RWDOOHQJWK:RUG2XWSXW
7RWDOOHQJWK:RUG,QSXW
$FWXDOYDOXH
6HWSRLQW
1R3.:
'ULYH 352),%86SDUWQHU6ORW
D[HVHDFKZLWKRQHHQFRGHUVWDQGDUGPHVVDJHIUDPH($3='$
&RQILJXUDWLRQ &\FOHV\QFKURQL]DWLRQ (QFRGHU
Figure 11-14 DP slave properties: ADI4
NC machine data
The general and axis-specific NC machine data should be set as follows:
Drive assignment:
The axis of the SIMODRIVE 611U drive module is assigned to the NC as the 1st machine
axis. This requires entry of its I/O address and message frame type under index 0:
● MD13050 $MN_DRIVE_LOGIC_ADRESS[0] = 4100
● MD13060 $MN_DRIVE_TELEGRAM_TYPE[0] = 102
The I/O address and the message frame type of the 1st axis of the ADI4 module will be
entered in the next free machine data (e.g. Index 3):
● MD13050 $MN_DRIVE_LOGIC_ADRESS[3] = 4200
● MD13060 $MDRIVE_TELEGRAM_TYPE[3] = 3
Assignment of the actual value channels:
Assignment of the 1st measuring system (index 0) of the machine axis to the measuring
circuit input of the SIMODRIVE 611U drive module is performed via the axis-specific
machine data:
● MD30220 $MA_ENC_MODUL_NR[0] = 1
with 1 = (Index 0 of the corresponding MD13050 + 1)