Siemens SINUMERIK 840Di sl - Page 424

NC Commissioning with HMI Advanced
11.5 Axes and spindles
Manual
424 Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
Zero speed tolerance
Position tolerance which a standing machine axis may not leave.
● MD36030 $MA_STANDSTILL_POS_TOL (standstill tolerance)
● Alarm "25040 Zero speed control" and follow-up mode
Delay time zero speed monitoring
Delay time after which the actual value must have reached the tolerance window "Zero
speed tolerance" when the setpoint position is reached.
● MD36040 $MA_STANDSTILL_DELAY_TIME (Zero-speed monitoring delay time)
● Alarm "25040 Zero speed control" and follow-up mode
Clamping tolerance
Tolerance window for a standing machine axis while the signal "Clamping active" is present
at the PLC interface.
● MD36050 $MA_CLAMP_POS_TOL (clamping tolerance)
● IS DB31,... DBX2.3 (clamping active)
● Alarm "26000 Clamping monitoring"
,6ಯ([DFWVWRSILQH
,6ಯ([DFWVWRSFRDUVHರ
6723B/,0,7B),1(
6723B/,0,7B&2$56(
67$1'67,//B326B72/
&/$03B326B72/
,6ಯ&ODPSLQJDFWLYHರ
7LPHW
6HWSRLQW
$FWXDOYDOXH
326,7,21,1*B7,0(
67$1'67,//B
'(/$<B7,0(
6
Figure 11-18 Static monitoring functions