Siemens SINUMERIK 840Di sl - Page 466

NC Commissioning with HMI Advanced
11.6 Handwheels
Manual
466 Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
Table 11-53 FB1 parameters (Excerpt)
Parameter Value Comment
MCPNum := 2 // Number of connected MCP
// MCP1 = HT 8
MCP1In ... // MCP1-Parameter ...
... ...
MCP1BusAdr := 39 // Via the switch S1 and S2 of the connecting device
// set "IP Address"
// MCP2 = MCP 483C IE
MCP2In ... // MCP2-Parameter ...
... ...
MCP2BusAdr := 192 // Via switch S2 at the MCP 483C
// set "IP Address"
MCPBusType := b#16#55 // Bus type: Ethernet
// BHG = HT 2
HHU := 5 // Bus type: Ethernet
BHGIn ... // BHG Parameter ...
... ...
BHGRecGDNo := 40 // Via the switch S1 and S2 of the connecting device
// set "IP Address"