Hardware Descriptions
2.5 SINUMERIK Industrial PC
Manual
72 Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
Features
The SINUMERIK industrial PC "PCU 50.3" provides, together with the MCI board, the basis
for the SINUMERIK 840Di sl. The PCU 50.3 has the following important features:
● Variants:
– Celeron M, 1.5 GHz, 512 MB SDRAM
– Pentium M, 2.0 GHz, 1024 MB SDRAM
● Hard disk min. 40 GB (replaceable)
● Operating system Windows XP ProEmbSys with Service Pack 2
● Robust design (continuous operation, high noise immunity)
● Compact dimensions for space-saving installation
● Easy installation with four screws on the rear of the operator panel front
● Mounting position and location to a large degree variable
● Screen resolution 640 x 480, up to max. 1600 x 1200
● Power supply: DC 24V
● Interfaces to peripheral devices:
– 1 x PROFIBUS DP (max. 12 Mbaud)
– 1 x DVI-I interface for external monitor
– 2 x Ethernet connections 10/100 Mbaud
– 1 x CF card shaft (covered)
– 4 x high-speed USB ports (USB 2.0)
● Interfaces to operator panel front:
– LVDS panel interface (channel 1 and optional channel 2)
– I/O USB panel interface
– Additional high-speed USB port (USB 2.0)
● Slots
– 1 x PCI (length: max. 265 mm, occupied by the MCI board)
– 1 x PCI (length: max. 175 mm, occupied with option MCI board extension slot variant)
Options
The following options are offered:
● Memory expansion up to max. 2048 MB
● External floppy disk drive
Fastening angle
Mounting brackets are required to mount the PCU directly behind the operator panel front:
● Mounting bracket MLFB: 6FC5 248-0AF20-2AA0
To Next Page
Loading...
