Description
3.6 Combined operation
Operating with the Local User Interface
Operating Manual, 06/2017, A5E31930478-05
47
Table 3- 9 Plug & Measure - Installation/replacement of an AM
Data synchronization/Action
Un-
changed
Re-
placed
The AM is to be replaced by a mod-
ule of the same type. The replace-
ment AM has a different serial
number than the AM connected
previously.
User action. Confirm <ENTER> or
reject <ESC>.
The AM data is transmitted from the
PM to the AM after confirmation, ex-
cept the identification data and the
Replacement of the AM electronics,
only permitted without own serial
number stored in the AM electronics
User action. Always confirm <ENTER>.
The AM data is transmitted from the
PM to the AM after confirmation, in-
cluding the identification data and the
Un-
changed
Re-
placed
AM electronics installed as "dedicat-
ed spare part". Service event.
Normal startup without message. The
default data of the AM set in the factory
is applied.
Un-
Re-
An AM is replaced by an AM of a
Automatic data synchronization
1)
, no
Un-
changed
New An additional AM of the same type is
to be installed.
An additional AM of a previously
installed type is installed again.
User action. Confirm <ENTER> or
reject <ESC>.
The data is transmitted after confirma-
tion, except the identification data and
the calibration parameters.
Un-
changed
New An additional AM of a type that has
not been connected before is to be
Automatic data synchronization
1)
, no
action required by user.
Data synchronization: PM parameters are transferred to the AMx (x=1 or 2), parameters of the
AMx are transferred to the PM
To Next Page
Loading...
Need help?
General
