Siemens TIM 1531 IRC User Manual

Block library TeleControl ST7
5.7 Master copies
TIM 1531 IRC
146 Operating Instructions, 02/2018, C79000-G8976-C468-02
•
Receiving operator typicals
(Bin04B_R, Ana04W_R, Cnt01D_R/Cnt04D_R, Dat12D_R, Dat256D_R)
The value 0 is not permitted!
If PartnerNo is < 1 or > 32000, an error message is entered in the
diagnostic buffer (event ID B100).
If the programmed value is permitted and correct but "PartnerNo" is not
found in the administration (DB BasicData), an entry is also made in the
diagnostics buffer (event ID B101). The CPU does not change to STOP.
The block is then no longer processed, however, until the error in the
programming has been corrected.
If the CPU receives a data frame for this typical, a check is made to
establish whether source subscriber number in the data frame is identical
to the "PartnerNo" programmed here. If the two subscriber numbers are
different, the received information is discarded and an error message is
entered in the diagnostic buffer (Event ID B130).
•
Sending operator typicals
(Cmd01B_S, Set01W_S, Par12D_S)
The value 0 is not permitted!
If "PartnerNo" is < 1 or > 32000, an error message is entered in the
diagnostic buffer (event ID B100).
If the programmed value is permitted and correct but "PartnerNo" is not
found in the administration (DB BasicData), an entry is also made in the
diagnostics buffer (event ID B101). The CPU does not change to STOP.
The block is then no longer processed, however, until the error in the
programming has been corrected.

Siemens TIM 1531 IRC Specifications

General

Brand	Siemens
Model	TIM 1531 IRC
Category	Controller
Language	English