Silca UC 199 - Unpacking; Machine Handling

2.2 UNPACKING
To remove the machine from the packing box:
1) cut the straps with scissors and remove.
2) raise the top part of the cardboard box.
3) loosen the screws, both on the front and back brackets that hold the machine to the pallet.
4) use the special spanner, to loosen the nuts on the machine’s feet.
5) remove the metal brackets and re-tighten the nuts on the feet.
6) check the contents in the box, that should comprise with the following:
1 UC199 key-cutting machine
1 set of documents, including: an operating manual, a spare parts list and a guarantee
1 power supply cable
1 serial cable
1
pouch/ tool kit
1 USB serial cable
1 Loader Unit (*)
NOTE: we strongly recommend you keep the packing intact for future transportation.
2.3 MACHINE HANDLING
When the UC199 has been unpacked, place it directly on its workbench; this operation should be carried out by
at least two people.
ATTENTION: Takecaretoliftthemachinermlyholdingthebase,andnootherpart.
Fig. 11
Operating Manual UC199
Copyright Silca 2012
12