Silca UC 199 - 2] Copy with Correction

5.5 [2] COPY WITH CORRECTION
- CONFIGURATION WITH OPTIONAL LOADER UNIT
Function used to correct (on the copy) any imperfections in the depth and/or cutting pitch on the original key
(generally used for very worn keys).
1- Copy from original
2- Copy with adjust.
3- Queue from PC
4- Calibrations >>
5- Maintenance
6- Options
1) with the pointer on position 2, press ENTER to select the function.
Operational keys: use the arrow keys [Up/Down] to move the cursor to the option required and press ENTER.
Original on right
Adaptor:
[START]
2) place the original key into the R/h clamp (remember to lower the gauge).
3) place the key blank (or blanks) into the loader, with their backs towards the operator.
PressSTARTtoseeonthedisplay,atrst:
Reading in progress …
ATTENTION: The key depth is not fully cut during reading.
and then:
Feeder ready
Depth adj. = +00
Spaces adj. = +00
Pcs: 1 / 1 [START]
4) Make the necessary adjustments to copy the key as required.
• Data alteration
The operator may alter the ‘depth’ and ‘space’ parameters.
Operational keys: to increase or decrease the parameters use a combination of the keys SHIFT + [arrow Up]
or SHIFT + [arrow Down].
Depths: (from -20 to +20 hundredths of a mm)
Enter the value (positive or negative) to move all the cuts closer to or farther from the key stop.
Fig. 46 – DEPTH ADJUSTMENTS
Operating Manual UC199
Copyright Silca 2012
35