Silca UC 199 - Adapter Calibration; Cutter Calibration

5.7.2 CUTTER CALIBRATION
This operation is necessary if existing cutters are sharpened and/or replaced with a tool of the same type.
NOTE: if the original Silca U01W cutter is replaced with another Silca original, it is not necessary to
repeat clamp calibration.
1- Cutting clamps
2- Cutter
3- Adaptors
Select “Cutter” and press ENTER.
Cutter
00 - U01/U01W
01 - 01
02-02 >>
29 - ...
30 - P41
Operating keys: arrow keys [< >] to set the adjustment value (positive or negative).
Adjustments can be made within an interval of +10 to -99 hundredths of a millimetre.
5.7.3 ADAPTER CALIBRATION
FUNCTION NOT AVAILABLE.
Operating Manual UC199
Copyright Silca 2012
49