Silca UC 199 - Machine Message; ATTENTION Messages; Error Message

5.10 MACHINE MESSAGE
5.10.1 ERROR MESSAGE
ERROR 1
Key gauge out
of place !
• Duringthereadingordecodingcyclethemachine’sopticalreaderveriedthatthekeygaugehadnotbeen
lowered
ERROR 2
Optical reader
not activated !
See operating manual.
• This message indicates that there is a fault in the optical reader or that something is obstructing its laser beam
before starting the reading or decoding cycle.
ERROR 3
Key cannot
be copied !
• The key cannot be cut by UC199 during the reading stage and at this point.
5.10.2 ATTENTION MESSAGES
ATTENTION
Depth limit
exceeded !
• During the cutting cycle one or more depth exceeded the maximum limit. These depths are automatically
aligned to the maximum permitted depth.
ATTENTION
Turn off machine
andtclamp:
L1
• A gauging operation that requires the Loader Unit (L1=Automatic clamp) is about to take place but the unit is
not detected. Remedy with: Maintenance (5) > Loader Unit (3) (see Ch. 5.8).
ATTENTION
Turn off machine
andtclamp:
L100
• A gauging operation that requires the standard cutting clamp (L100=Standard clamp) is about to take place
but the clamp is not detected. Remedy with: Maintenance (5) > Loader Unit (3) (see Ch. 5.8).
Operating Manual UC199
Copyright Silca 2012
65