EasyManua.ls Logo

Silca UC 199 - General Warnings; Safety Regulations

Silca UC 199
107 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GENERAL WARNINGS
UC199 is designed to the principles of European Standards (CE).
Right from the design stage solutions have been adopted to eliminate hazards for the operator in all the stages
of use: handling, regulation, use and maintenance.
The materials used in manufacture and the components employed in using UC199 are not dangerous and ensure
that the machine complies to current standards.
Silca S.p.A. has also experimented and applied numerous technical solutions that allow the key-cutting machine
to optimize the quality of the cut keys.
To guarantee maintaining these results over time, please follow the instructions below:
•
Observe the procedures described in this manual;
•
Always use Original Silca Tools as they are designed to make the best of
UC199
and provide quality key-
cutting;
•
Use Silca key blanks, made with top quality materials;
•
Have the key-cutting machine checked periodically by an authorized Silca After-Sales Service Centre (list at
the end of this manual); always use Silca Original Spare Parts. Beware of imitations!
NORMAL USE
UC199 is a key-cutting machine and must be installed and used according to the rules and specications
established by the manufacturer.
Any other use different from that indicated in this manual will cause the forfeiture of all customers’ rights to make
claims on Silca S.p.A. and may be an unknown source of hazard for the operator or third parties.
ATTENTION: Negligent use or failure by the operator to observe the instructions in this
manual are not covered by the warranty and the manufacturer declines any responsibility in
such cases.
RESIDUAL RISKS
No further risks will arise when properly using the UC199.
SAFETY REGULATIONS
• Always disconnect the machine when it is not in use or when performing maintenance operations.
• Check the electrical wiring periodically; replace any wires that show signs of wear.
• Always work with dry hands free of grease or oil.
• Never pull hard on the power lead and make sure it does not come into contract with oil, sharp objects
or heat. Never remove the earth wire from the plug. Make sure the earth wire connection is sound.
• Do not use the machine in dangerous environments (wet or damp).
• All visitors, especially children, must stay at a safe distance from the machine and must never come
into contact with the electric wiring.
Operating Manual UC199
Copyright Silca 2012
3

Table of Contents

Related product manuals