5.1 INITIAL OPERATION
When the key-cutting machine has been placed on its workbench and connected to the mains (Ch. 3.3), proceed
as follows:
1) turn on the machine by means of the master switch/emergency button (turn 45° clockwise).
2) to check or alter the parameters for use of the machine, consult the “Options [6]” (Ch.5.9).
When the machine is turned on, for a few seconds the display shows the internal software version and the
machine model:
UC199
Version x.x.xxx
Vers. DB xx.xx
Thedisplayshows(onlyonrststart-up):
Select language = 2
1-Italiano 2-English
3-Deutsch 4-Francais
5-Espanol
Operational keys: arrow keys [< >] to choose the option, ENTER to conrm.
Save the
modication?
No=STOP Yes=ENTER
The message will appear:
Zero the axes!
[START]
NOTE: This message will appear every time the machine is started. Press START, the machine checks
the position of the carriages then goes on to:
MAIN MENU
1- Copy from original
2- Copy with adjust.
3- Queue from PC
4- Calibrations >>
5- Maintenance
6- Options
Operational keys: use the arrow keys [Up/Down] to move the cursor to the option required and press ENTER.
The >> symbol indicates that the menu contains other items which can be reached with the arrow key [Down].
Operating Manual UC199
Copyright Silca 2012
28
To Next Page
Loading...
