Silca UC 199 - Page 43

• IF THE OPTIONAL FEEDER IS INSTALLED:
1- [316]
Pieces: 1 of: 3
Manual cycle = START
Press START to start the MANUAL CYCLE
1+ [316]
Pieces: 1 of: 1
MAN. CYC. IN PROGRESS
Press CLEAR to
stop the cycle
MANUAL CYCLE
Themanualcycleisenabledbydefault:ifthereareanumberofjobsinthePCqueue,starttherstone;when
thejobisnishedthemachinewillstoptowaitforneworders.
Press SHIFT+START to start the AUTOMATIC CYCLE.
AUTOMATIC CYCLE
Theautomaticcyclecanbeenabled:ifthereareanumberofjobsinthePCqueue,starttherstone;whenthe
jobisnishedthemachinedoesnotwaitfornewordersbutstartsthesecondjobimmediately.
ATTENTION: iftherearekeyssetupinthefeederforseveraljobs(iftheproleisnotthe
same) these must be checked before starting work.
When CLEAR is pressed (for about 2 seconds) the cycle stops. The cut being made will be
completed and then the carriages will stop in their initial position.
Stopping cycle
in progress …
Feeder ready
Adaptor:
Pcs.:2/3 [START]
Operating Manual UC199
Copyright Silca 2012
39