5-1
Chapter 5
Installing 4010ES systems
Introduction This chapter describes how to mount the 4010ES back boxes to a wall, and install basic
system components into the boxes.
Before beginning the installation, review this chapter to get a sense of the types of bays and
modules that make up the FACP.
IMPORTANT: Verify ES Panel Programmer, Executive, and Slave Software compatibility
when installing or replacing system components. Refer to the technical
support website for up-to-date compatibility information.
In this chapter This chapter covers the following topics:
Topic Page
Mounting the panel 5-2
General field wiring guidelines 5-5
Connecting 4010ES basic components 5-7
RUI wiring 5-11
Installing the optional modules 5-13
Address configuration DIP switch 5-14
Connecting main system power 5-16
To Next Page
Loading...
