Network Echosounder
Select to share transducers from this unit with other units
connected on the Ethernet network. In addition, the setting must
be selected in order to see other enabled sonar devices on the
network.
When unselected, transducers connected to this unit cannot be
shared with other units connected on the network, nor can it see
other sources on the network that have this feature enabled.
For more information about how to setup the echosounder, refer to
the separate Installation manual.
Network echosounder mode
The network echosounder mode setting selects whether only one
or multiple echosounder sources can be selected at the same time.
Ú
Note: Single source is automatically selected if there are older
legacy echosounders on the network. You cannot change this
setting if older legacy echosounders are on the network. Multi-
source mode should be selected if no legacy echosounder is
connected to the network.
Ú
Note: When changing the mode to multi-source you must wait
30 seconds and then power down all sources. Wait 1 minute,
then restart all connected sources.
Use network depth and temp data
The unit can share depth and temperature data from an Ethernet
networked echosounder source over the NMEA 2000 network.
Use this option to select from which Ethernet network source the
data is shared.
158
Echosounder | GO XSE/XSR Operator Manual
To Next Page
Loading...
Need help?
General
