Menu options
You can use menu options to:
• navigate to cursor
• navigate to a waypoint
• navigate a route
While navigating, the menu expands to provide options to:
• skip waypoints when navigating a route
• restart navigating to cursor, a waypoint or a route
• cancel navigating to cursor, a waypoint or a route
Navigating with the autopilot
When you start navigation on a system with autopilot functionality,
you are prompted to set the autopilot to navigation mode.
Ú
Note: The prompt to set the autopilot to navigation mode is
disabled if the boat type is set to SAIL in the Autopilot
Commissioning dialog.
If you choose not to engage the autopilot, the autopilot can be set
to navigation mode from the Autopilot Controller later on.
For more information about autopilot functionality, refer to the
autopilot chapter of the autopilot being used.
Navigation settings
Navigating | GO XSE/XSR Operator Manual
65
To Next Page
Loading...
Need help?
General
