Waypoint alarm settings
You can set an alarm radius for each individual waypoint you create.
The alarm is set in the Edit Waypoint dialog.
Ú
Note: The waypoint radius alarm must be toggled ON in the
alarm dialog to activate an alarm when your vessel comes
within the defined radius. For more information, refer to "Alarm
dialogs" on page 199.
Routes
About routes
A route consists of a series of routepoints entered in the order that
you want to navigate them.
When you select a route on the chart panel it turns green, and the
route name is displayed.
Creating a new route on the chart panel
1. Activate the cursor on the chart panel
2. Select the new route option from the menu
3. Position the first waypoint on the chart panel
4. Continue positioning new routepoints on the chart panel until
the route is completed
5. Save the route by selecting the save option in the menu.
Edit a route from the chart panel
1. Select the route to make it active
2. Select the route edit option in the menu
3. Position the new routepoint on the chart panel:
-
If you set the new routepoint on a leg, a new point is added
between existing routepoints
- If you set the new routepoint outside the route, the new
routepoint is added after the last point in the route
4. Drag a routepoint to move it to a new position
5. Save the route by selecting the save option in the menu.
Ú
Note: The menu changes depending on the selected edit
option. All edits are confirmed or cancelled from the menu.
Waypoints, routes, and tracks | GO XSE/XSR Operator Manual
55
To Next Page
Loading...
Need help?
General
