Creating routes using existing waypoints
A new route can be created by combining existing waypoints from
the Routes dialog. The dialog is activated by using the Waypoints
tool on the Home page and then selecting the Routes tab.
Creating a route based on a trip
You can create a route based on a historical trip. Select a trip in the
TripIntel history dialog and then the create route option.
Converting tracks to routes
You can convert a track to a route from the edit track dialog. The
dialog is activated by activating the track, and then:
• Selecting the track's pop-up
• Selecting the track in the menu
The edit track dialog can also be accessed by selecting the
waypoints tool on the home page.
Dock-to-dock Autorouting and Easy Routing
The Dock-to-dock Autorouting and Easy Routing features suggest
new routepoint positions based on information in the map and on
your boat's size. Before you can start using these features the boat
draught, width and height must be entered into the system. The
boat settings dialog is automatically displayed if the information is
missing when you start the feature. To enter boat settings, refer to
"System settings" on page 214.
Ú
Note: It is not possible to start the Dock-to-dock Autorouting or
Easy Routing if one of the selected routepoints is located in an
unsafe area. A warning dialog is displayed, and you have to
move the relevant routepoint(s) to a safe area to proceed.
Ú
Note: If no compatible cartography is available, the Dock-to-
dock Autorouting or Easy Routing menu option is not available.
Compatible cartography includes C-MAP MAX-N+, Navionics+
and Navionics Platinum. For a full selection of available charts,
visit www.c-map.com or www.navionics.com.
1. Position at least two routepoints on a new route, or open an
existing route for editing.
2. Select the Dock-to-dock Autorouting menu option, followed by:
56
Waypoints, routes, and tracks | GO XSE/XSR Operator
Manual
To Next Page
Loading...
Need help?
General
