Turn variables:
• Course change per leg
• Leg distance
• Number of legs
Square
Steers the vessel in a square pattern, doing 90° course changes.
Turn variable:
• Leg distance
• Number of legs
S-turn
Makes the vessel yaw around the main heading.
Turn variables:
• Turn radius
• Course change
• Number of legs
Trolling motor speed control
In Heading lock mode, Nav. mode and in Turn pattern steering the
autopilot system can control the trolling motor speed.
The set target speed is displayed in the autopilot controller.
There are two ways to control the target speed of the trolling motor:
• Propeller rate, set as a percentage of power (A)
• Cruise control speed (B)
Switch between the speed options by selecting the speed icon.
The speed is increased/decreased in preset steps by selecting the
plus and minus buttons. The speed can also be set manually by
selecting the speed field (C).
Recording and saving a track
A track can be saved as a route from the autopilot controller. If track
recording is disabled, the function can be enabled from the
autopilot controller.
For more information, refer to "Waypoints, routes, and tracks" on page 53.
94
Trolling motor autopilot | GO XSE/XSR Operator Manual
To Next Page
Loading...
Need help?
General
