Autopilot settings
The Autopilot settings dialog depends on which autopilot
computer that is connected to the system. If more than one
autopilot is connected, the Autopilot settings dialog shows option
for the active autopilot.
The settings are made during commissioning of the autopilot. Be
careful of changing settings after commissioning is completed.
Common user settings
The following user settings are common to all autopilots.
Chart compass
Select to display a compass symbol around your boat on the chart
panel. The compass symbol is off when the cursor is active on the
panel.
Autopilot
Switches the view to the last active page with the autopilot
controller open.
NAC-1 specific user settings
Steering response
Used to increase or decrease the steering sensitivity. A low response
level reduces the rudder activity and provides a looser steering. A
high response level increases the rudder activity and provides
tighter steering. A too high response level will cause the boat to
make S movements.
84
Autopilot | GO XSE/XSR Operator Manual
To Next Page
Loading...
Need help?
General
