Single Power-Pole controller Dual Power-Poles controller
On a dual controller you can raise and lower the Power-Poles
separately, or press the sync (links) button to allow for control of
both with a single press of the auto buttons or the manual up and
down buttons.
Stay connected
Select the Settings button on the Power-Pole controller to open the
Power-Pole Settings dialog where you can select to stay connected
to all paired Power-Pole anchors.
Ú
Note: Selecting to Stay connected speeds up access to the
controls, but the anchors cannot be controlled from another
unit when it is selected. Turn off this option to allow connection
from other units.
The Power-Pole Settings dialog also provides the option to add or
remove Power-Poles. This option opens the same Bluetooth Devices
dialog you open from the Wireless settings dialog. Refer to "Bluetooth
options" on page 202.
Pairing with dual Power-Poles
If dual Power-Poles are installed on your boat, the one that is paired
first automatically becomes Port and the second is set to Starboard
in the Power-Pole controls.
To swap them around, unpair the connected Power-Poles. And
then, toggle off and on Bluetooth in the Wireless settings dialog to
reset the Bluetooth memory. Once Bluetooth has been toggled
back on, proceed in pairing the Power-Poles in the correct order.
Integration of 3 party devices | GO XSE/XSR Operator Manual
233
To Next Page
Loading...
Need help?
General
