139
SJ6826RT, SJ6832RT
213560ABA
General Section 5 – Procedures
Applying Grease
1. Remove the cap from the grease tting.
2. Using a clean rag, wipe off any dirt or debris
from the grease tting.
3. Connect a grease gun to the grease tting, and
pump until a small amount of grease can be
seen coming out around the joint or bearing.
4. Disconnect the grease gun.
5. Wipe off any excess grease from around the
joint or bearing, and from the grease tting.
6. Replace the grease tting cap.
To order go to Discount-Equipment.com
To Next Page
Loading...
