EasyManua.ls Logo

Skyjack SJ6826RT - Engine Cranks but Does Not Start - Kubota Diesel

Skyjack SJ6826RT
177 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
89
SJ6826RT, SJ6832RT
213560ABA
Electrical System Section 4 – Troubleshooting Information
25. Defective Starter Contactor 32ACR. Check contactor. Replace if defective.
26. Loose or broken wire #00 from Starter Contactor
32ACR to Base terminal block TB-1.
Check continuity. Replace if defective.
27. Loose or broken wire #103 from Main Power
Disconnect S1 to Starter Contactor 32ACR.
Check continuity. Replace if defective.
28. Loose or broken wire #57 from Starter Contactor
32ACR to Starter Motor.
Check continuity. Replace if defective.
29. Loose or broken wire #00 from battery negative (-) to
Starter Motor.
Check continuity. Replace if defective
30. Defective Starter Motor. Check Motor. Repair or replace if defective.
4.2-6 Engine Cranks but Does not Start – Kubota Diesel
1. Open diode D32A from Engine Start switch S32 to
Engine Glow Plug/Choke switch S31.
(Diode located in Engine Harness.
Refer to Engine wiring diagram- Diesel Fuel System).
Check diode.
Replace if defective.
2. Loose or broken wire #37 from Engine Harness to
Diesel Valve solenoid 2D37.
Check continuity. Replace if defective.
3. Loose or broken wire #57 from Starter Contactor
32ACR to Diesel Valve solenoid 2D37.
Check continuity. Replace if defective.
4. Loose or broken wire #00 from Diesel Valve solenoid
2D37 to battery negative (-).
Check continuity. Replace if defective.
5. Defective Diesel Valve solenoid 2D37. Check coil. Replace if defective.
6. Loose or broken wire #31 from Engine Harness to
Glow Plug Relay 31CR.
Check continuity. Replace if defective.
7. Loose or broken wire #02 from Engine Harness to
Glow Plug Relay 31CR.
Check continuity. Replace if defective.
8. Defective Glow Plug Relay 31CR. Check Relay. Replace if defective.
9. Loose or broken wire #103 from Main Power
Disconnect switch S1 to Glow Plug Relay 31CR.
Check continuity. Replace if defective.
10. Loose or broken wire #91A from Glow Plug Relay
31CR to Engine Glow Plugs EGP1.
Check continuity. Replace if defective
11. Defective Engine Glow Plugs EGP1. Check glow plugs. Repair if necessary.
To order go to Discount-Equipment.com

Table of Contents

Related product manuals