108
SJ6826RT, SJ6832RT
213560ABA
Section 4 – Troubleshooting Information Electrical System
16. Loose or broken wire #02 from Outrigger Lift Enable
Relay 65CR to Base terminal block TB-1.
Check continuity. Replace if defective.
17. Defective Outrigger Lift Enable Relay 65CR. Check Relay. Replace if defective.
18. Open diode D14A-2 at base terminal block TB-1. Check diode. Replace if defective.
4.2-25 Platform does not Lift from Platform or Base Control Console with Outriggers
Extended or Retracted
1. Defective Outrigger Lift Enable Relay 65CR. Check Relay. Replace if defective.
2. Defective Outrigger Lift Disable Relay 17DCR. Check Relay. Replace if defective.
3. Loose or broken wire #14 from Base terminal block
TB-1 to outrigger/ generator harness connector.
Check continuity. Replace if defective.
4. Loose or broken wire #02 from Base terminal block
TB-1 to outrigger/ generator harness connector.
Check continuity. Replace if defective.
5. Loose or broken wire #14 from Base terminal block to
Control Module CM1 at pin #P2-3.
Check continuity. Replace if defective.
6. Defective Up Relay 14CR. Check Relay. Replace if defective.
7. Loose or broken wire #36A from Outrigger Lift Enable
Relay 65CR to Up Relay 14CR.
Check continuity. Replace if defective.
8. Loose or broken wire #14A from Up Relay 14CR to
Base terminal block TB-1.
Check continuity. Replace if defective.
4.2-26 Down Function Inoperative from Platform
1. Lift/Off/Drive Select switch S3 is set to an incorrect
mode.
Select Lift. Check switch. Replace if defective.
2. Defective Joystick S7.
Operate Joystick. Check output to wire #A P1-6.
Replace if defective
3. Loose or broken wire #A from Joystick S7 to Lift/Off/
Drive Select switch S3.
Check continuity. Replace if defective
4. Defective Lift/Off/Drive Select switch S3.
Check continuity between wire #A and wire #13 on
switch when Lift selected.
Replace if defective.
To order go to Discount-Equipment.com
To Next Page
Loading...
