Skyjack SJ6826RT - Replacing the Oil Filter Cartridge; Changing the Oil

150
SJ6826RT, SJ6832RT
213560ABA
Section 5 – Procedures Engine
5.3-8 Replacing the Oil Filter Cartridge
Kubota recommends replacing the oil cartridge every
400 hours.
IMPORTANT
Be sure to stop the engine before changing the oil
lter cartridge.
1. Remove the old oil lter cartridge with a lter
wrench.
2. Prepare a new lter cartridge by applying a light
coating of oil to the new cartridge gasket.
3. Install the new cartridge by screwing it in by
hand.
IMPORTANT
Do not over tighten the lter as it may cause
deformation of the rubber gasket.
4. The engine oil level normally decreases a little
after replacing the oil lter cartridge, so run the
engine for 10 to 15 minutes, then shut it off and
allow it to cool.
5. Check for oil leaks around the gasket, and if no
leaks are found, check the oil level using the
dipstick.
6. Replenish the oil if needed.
5.3-9 Changing the Oil
Kubota recommends changing the oil every
200 hours.
1. With the aerial platform on a level surface, start
the engine and warm it up for approximately 5
minutes. Shut off the engine.
2. Place a container underneath the engine’s oil
pan drain plug.
3. Remove the drain plug, and allow the oil to drain
completely.
4. Screw the plug back into the oil pan, tightening
it to 24 – 27 ft•lb (33 – 37 N•m).
5. Unscrew one of the oil ller caps and ll the
engine with new oil, up to the upper line on the
dipstick. Reinstall the cap.
Above 25°C (77 °F) SAE30, SAE 10W-30 or 10W-40
0° to 25°C (32°F to 77°F) SAE20, SAE10W-30 or 10W-40
Below 0°C (32°F) SAE10W, SAE10W-30 or 10W-40
IMPORTANT
If changing to a different oil manufacturer or
different oil viscosity, be sure to completely drain
all of the old oil rst before relling with new oil.
Do not mix oil of different types.
6. Start the engine and run it for 10 to 15 minutes,
checking for leaks at the oil pan drain plug.
Oil filler cap
Dipstick
Drain plug
To order go to Discount-Equipment.com