149
SJ6826RT, SJ6832RT
213560ABA
Engine Section 5 – Procedures
5.3-6 Replacing the Fuel Filter Element
(Kubota D902)
Kubota recommends replacing the fuel lter every 400
hours.
1. Close the fuel lter lever (turn counterclockwise).
2. Unscrew the retaining ring and remove the lter
cup.
3. Remove the old fuel lter element.
4. Rinse the inside of the cup with diesel fuel or
kerosene.
5. Install a new fuel lter element, and reassemble
the fuel lter cup and retaining ring, ensuring all
components are free of dirt and dust.
6. Bleed the fuel system of air (refer to 5.2-7).
Retaining Ring
Filter Cup
Filter Element
Fuel Lever
Open
Closed
5.3-7 Bleeding the Fuel System of Air
(Kubota D902)
Bleeding the fuel system of air is required after
changing fuel hoses or lters, or after the fuel tank has
become empty.
1. Allow the engine to cool, if it has been running.
2. Fill up the fuel tank with fuel.
3. Open the fuel lter lever (vertical position).
Fuel Lever
Open
Closed
4. Open the air vent plug on the top of the fuel
injection pump a few turns. Some air bubbles
should come out.
5. When no more air bubbles are seen, close the
air vent plug.
To order go to Discount-Equipment.com
To Next Page
Loading...
